Products Description
DS200CDBAG1BBB controller
DS200CDBAG1BBB controller
Consider that the GE Contactor Driver Board DS200CDBAG1A is regularly modified to improve the device's components, reliability, and operation.However, compatibility between all revisions is guaranteed.For example, you can buy the latest version of a development board and install it on your drive, and it will be compatible with the older version you deleted.If the circuit board needs to be replaced, installation is quick and easy.This is due to the driver's design allowing easy access to the circuit board.For safety reasons and to protect all components, you must remove power from the drive.Wait a few minutes to remove all power.Then test any circuits to make sure all power is disconnected before touching them with your hands.Open the cabinet door of the drive where the damaged board is located.You may find that there are multiple wires connected to the damaged circuit board.Before you remove them, label any unlabeled ones to make installation easier.Connector 1TB has a 2 part connector.Use a screwdriver to separate the two parts and disconnect the connector from the circuit board.A jumper is located on the circuit board for use by the factory during the manufacturing process.It is used for testing.This is a 3 pin jumper, pin 1 and pin 2 should remain covered.Do not attempt to change the jumper position.
Power supply and protection:
Ø Power supply: Dual power redundant input, DC (9-36) V, typical DC24V, power consumption less than 4W, with DC1500V voltage isolation and reverse protection function, industrial terminal interface
Ø Relay alarm output: Fiber optic link fault and power supply fault alarm output, contact capacity: DC48V/1A, industrial terminal interface
Mechanical characteristics:
*External dimensions: 132mm× 105mm× 52mm
*Shell: IP30 protection level, corrugated aluminum reinforced casing
*Installation method: 35mm DIN rail installation
*Net weight: 800g
Work environment:
*Working temperature: -10-70 ℃ (-40~+85 ℃ wide temperature optional)
*Relative humidity: ≤ 90% (non condensing)
*Storage temperature: -40~80 ℃
Test certification:
*EN55022:2010 (RE) Band Width: 120KHz Frequency Range: 30MHz to 1000MHz
*EN61000-4-2:2001 (ESD) Air discharge voltage:± 8KV contact discharge voltage:± 4KV
Criterion: B Level 2
*EN61000-4-3:2006 (RS) 3V/m (80-1000MHz) Criteria: A Level 2
*Test Standards: EN1122:2001 EPA3050B, EPA3052 EPA3540C, EPA3060A
*Testing item: Pb Cd Hg Cr6+PBBs
*Test Results: N.D
The networking structure of the profibus dp redundant fiber optic repeater implementation:
Tags:
Technical parameter
Business License
Main products
